Finite element analysis basics every engineer should know
Written by LitCareer · 13 Oct 2026 · 2 min read
How FEA works, the steps of a good analysis, and the mistakes that make results look right but be wrong.
What FEA does
Finite element analysis predicts how a part or structure responds to loads, heat, vibration and other conditions. The geometry is divided into many small elements connected at nodes. The software solves equations for each element and combines them to estimate displacements, stresses, temperatures or natural frequencies.
The steps of an analysis
- Define the question: What do you need to know? Maximum stress, deflection, safety factor, natural frequency?
- Simplify the geometry: remove small features that don't affect the result, use symmetry where valid.
- Assign materials: elastic properties at minimum; plasticity, temperature dependence or other behaviour if needed.
- Mesh: choose element types and sizes, with finer elements where stresses change quickly.
- Apply boundary conditions and loads that reflect reality.
- Solve and check: look at deformation first, then reaction forces, then stresses.
- Verify and report: compare with hand calculations, test data or known solutions.
Common mistakes
- Unrealistic constraints: fixing a face that can actually move creates false stress peaks.
- Singularities: sharp re-entrant corners and point loads give stresses that keep rising as the mesh is refined. Interpret them carefully or model fillets and distributed loads.
- No mesh convergence check: refine the mesh until key results stop changing significantly.
- Wrong units: keep a consistent unit system throughout.
- Trusting colourful plots without checking reactions and deformation.
Linear versus nonlinear
Linear static analysis assumes small deformations, linear elastic materials and unchanging contact. Large deformation, plasticity, contact and many polymers and composites need nonlinear analysis, which requires more care with convergence.
How to learn
Start with simple problems that have hand-calculation answers, such as a cantilever beam or a plate with a hole, and compare. This builds intuition and the habit of checking results.
Your next steps
- Write down the question the analysis must answer
- Check deformation and reaction forces before stresses
- Always run a mesh convergence check
- Validate with hand calculations or test data
General guidance for learning, not professional, legal or financial advice. Want help for your own situation? Book 1:1 career help.


